英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字，中文词皆可：

安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • Week 3: Computors and On -Board Diagnostics Flashcards
    What is PCM diagnotic software component It is a part of the PCM software that monitors engine condutions necessary to run diagnotic check If a failure is detected with the On-Board Diag: DTC will be stored and MIL illuminated during the second trip Types of OBD diagnostics What is the difference between Continous test and Non-Continuous test?
  • OBD2 Monitors Not Ready: Causes Fixes - Daily Car Tips
    Either way, this post breaks down exactly why OBD2 monitors not ready happens, what the monitors actually do, and the step-by-step process to get them ready before your next inspection
  • Presentation - BILLINGS CAREER CENTER SKILLSUSA
    The task manager will not authorize the start of the O2S monitor until the engine has reached operating temperature and the system has entered closed loop The task manager will not authorize the start of the EGR monitor when the engine is at idle, because the EGR is always closed at this time
  • OBDII inspection 2 monitors incomplete. | Jeep Wrangler Forum
    First, ensure your battery is in good condition, as a weak battery can prevent monitors from running Try performing specific drive cycles tailored to Chrysler vehicles to reset the monitors, paying close attention to RPM and speed requirements
  • OBD II Terminology - RLEscalambre
    Before introducing the Controller Area Network (CAN) in 2008, the PCM did not have to switch to Complete, Done, or Ready if a readiness flag monitor test failed
  • RepairCare 7-2010 - Department of the Environment
    What you may not be aware of is that some defects will block other monitors from running For example, an O2 sensor defect that has generated a trouble code is likely to prevent a catalyst monitor from running since this sensor is used in running the catalyst monitor
  • Q A: How to Pass OBD II Emissions Tests with Check Engine Light On?
    Under some situations the Task Manager will not run a monitor if the MIL is illuminated and a fault is stored from another monitor In these situations, the Task Manager postpones monitors pending resolution of the original fault
  • Solved: While discussing PCM monitor tests: Technician A says that some . . .
    The PCM does not stop executing the monitor only because the monitor status for a specific readiness monitor is Ready or Complete The PCM runs a monitor whenever the enabling requirements for that monitor are met
  • End Wrench 08. 05 - Automotive Tech Info
    It’s important to note that for some monitors to run, you must have fuel levels and charging system voltages within certain parameters, and in some cases a whole series of events must occur or be main-tained for a specified period of time prior to the PCM authorizing test initiation





中文字典-英文字典  2005-2009